Extron electronic RGB 201 Rxi manual Installation and Operation, cont’d

Installation and Operation, cont’d

2. Insert the machine screws provided in the optional mounting kit (part #70-077-02) through the slots in the through-desk mounting brackets, and loosely secure the brackets to the interface (figure 2-4).

3. Hold the interface with attached brackets against the underside of the desk/table. With a soft pencil mark the location of holes for screws on the desk. Mark the opening, approximately 1.8" x 8.9" ( 4.6 cm x 22.6 cm).

4. Cut out the material from the installation area with a jigsaw. Check the opening size by inserting the interface part way through the hole. If needed, use a saw, file or sandpaper to enlarge the hole. Smooth the edges of the hole with sandpaper.

5. Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot holes in the desk or table at the marked screw locations. The holes should be drilled from the underside or inside (concealed side) of the furniture, where the interface will be located.

6. Secure the interface to the desk with the provided wood screws.

7. To adjust the height of the interface within the desk, slide the interface up or down to the desired position, then tighten the screws that attach the brackets to the interface.

2-8 RGB 201 Rxi Universal Interface • Installation and Operation