Extron electronic RGB 201 Rxi manual Connect the cables to five BNCs

Installation and Operation, cont’d

D	BNC output connectors — Connect a coaxial cable between the
	display (projector or monitor) and these rear panel	R	G	B
	BNC connectors.
		H	V	S
	For RGBHV (separate H and V sync) output,	RGBHV
	connect the cables to five BNCs.	R	G	B

For RGBS (composite sync), connect the cables to four BNCs.

For RGsB (sync on green, SOG) and RsGsBs (sync on all), connect the cables to three BNCs. Also select the SOG option on the rear panel DIP switch (see item 6 , Dip switches in this chapter.

HVS

RGBS

R G B

HVS

RGsB

RsGsBs

E	Audio output connector — Connect an audio
	device, such as powered speakers, to this 3.5 mm, 5-pole captive
	screw connector for balanced or unbalanced audio output.
	Figure 2-8 shows how to wire the captive screw audio connector.
	The connector is included with the interface, but you must
	obtain the cable. Insert the wires into the appropriate openings
	in the captive screw connector. Tighten the screws on top to
	fasten the wires.
	C Wiring the audio incorrectly can damage the audio
		output circuits.
		Connect the sleeve(s) to ground (	). Connecting
		the sleeve(s) to a negative (-) terminal will damage
		audio output circuits.

Do not tin the wires!

Tip	L	Tip
Ring		Sleeve
Sleeves		Tip
Tip	R
Ring		Sleeve

Balanced Audio Unbalanced Audio

Figure 2-8 — Wiring the audio output connector

L R

2-12 RGB 201 Rxi Universal Interface • Installation and Operation