Extron electronic SW DVI A Series Command/response table for SIS commands, Input selection

4-	Command/response table for SIS commands
4
	Command	ASCII Command	Response	Additional description
SW		(host to unit)	(unit to host)
	Input selection
DVI
	Select video and audio input	X!!	In X!All ]	Select both audio and video inputs X!.
A	Select video input only	X!&	In X!Vid ]	Select video input X!.
	Select audio input only	X!$	In X!Aud ]	Select audio input X!.
Series•
	Request status of all inputs	0LS	Sig X@• X@• X@• X@]
	Input video signal sensing
SIS				X@= input signal status:
Configuration	Video mute	X@B	Vmt X@]	1 = present; 0 = not present.
				Mute the video signal.
		X!LS	X@]	N This command is case-sensitive.
	Request status of an individual			N This command is case-sensitive.
	input
	Video muting
and	Read video mute	B	X@]	Show video muting status X@:
Control				1 = muted, 0 = unmuted.
	Audio muting
	Audio mute	X@Z	Amt X@]	Mute the audio signal.
	Read audio mute	Z	X@]	Show audio muting status X@:
				1 = muted, 0 = unmuted.
	Front panel lockout
	Enable/disable executive mode	X@X	Exe X@]	For X@: 1 = front panel locked;
				0 = front panel unlocked (default).
	Lockout status	X	X@]	Show executive mode on/off status.

Command/response table for SIS commands (continued)

	Command	ASCII Command	Response	Additional description
		(host to unit)	(unit to host)
	IR receiver disable from front panel
	Enable/disable IR receiver	X@* 65#	IRDisable X@]	Disable the IR remote receiver on the front panel
SW				from receiving signals from the IR remote control.
	IR status	65#	X@]	View IR receiver status. For X@, 0 = off, 1 = on.
DVI
	Firmware version, part number, and information requests
A	Request information	I	V X!• A X!• Vmt X@• Amt X@]
Series•	Request part number	N	60-840-xx ]	Show switcher part number.
				Show the selected video and audio input numbers,
				and the video and audio muting status.
SIS				SW2 = 60-840-01, SW4 = 60-840-02.
	Query firmware version	Q	X#]	Show firmware build number X#, expressed to the
Configuration
				second decimal place.
	Example:	Q	1.01 ]
	Query EQ DIP switch status	41S	Dip X@• X@• X@• X@]
				X@= DIP switch status for each input.
				1 = on (up); 0 = off (down).
and			Asw X@]	N This command is case-sensitive.
	Query autoswitch mode	72#		Show on/off status of autoswitching.
Control
	Reset	EZXXX }	Zpx ]	Reset the switcher to factory default values.
				For X@: 0 = disabled, 1 = enabled.
	Reset
	Upload firmware
4-5	Upload firmware	EUpload }	...go	Upl appears after upload is complete.
			Upl ]

SIS Configuration and Control, cont’d