Australia
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
Fit the plastic blanking plugs to the fixing holes. Remove the 4mm Allen screws from the top corners of the fascia and fix the front handrail in position.
Fitting the Splashback
The cooker can be installed with or without the supplied splashback. To fit the splashback, remove the two fixing screws (3mm hexagonal socket head) and nuts that pass through the top of the rear flue grille. Hold the splashback in position. From the rear, refit the two fixing screws and nuts.
Fitting the Stability Bracket
The stability bracket supplied with the cooker must be fitted. Read the leaflet supplied with the bracket, and fit it as follows:
1.Place the cooker in its intended position and level the cooker.
2.Draw a pencil line 70mm from the front edge of the levelling feet.
3.Mark the centre line for the bracket by measuring 550mm from the left hand side of the cooker.
4.Move the cooker forward.
5.Measure back from the pencil line 500mm to locate the front edge of the bracket. Position the bracket so that it is away from centreline of the cooker to reduce the possibility that it will trap the electrical connection cable or gas hose. Fix the bracket to the floor.
6.Measure the height from floor level to the engagement edge at the rear of the cooker. Add 3mm to this dimension and assemble the stability bracket to this height (i.e. from floor level to the underside of the top member), and ensure the bracket does not foul the oven burner assembly:
25
