Australia
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
Fitting the Restraining Chain | Hook the other end of the chain to the wall fixing: | ||||||
The restraining chain must be fitted. |
| ||||||
The length of chain between the appliance and the wall |
| ||||||
fixing should prevent strain on the gas and electricity |
| ||||||
connections, but still allow access to unhook the chain |
| ||||||
when the cooker is pull forward. |
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Fix the supplied hook securely to the wall.
Measure the length of chain required. Use the hexagon- headed screw, washers and bolt supplied in the restraining chain kit to fix the chain to one of the holes at the top of the flue trim bracket:
���������
�������
�����
��������
Gas Connection
The Gas supply needs to terminate with a down facing bayonet. The rear cover boxes limit the position of the supply point.
View from the rear
APosition for gas supply connector B Appliance gas inlet
Because the height of the cooker can be adjusted and each connection is different, it is difficult to give precise dimensions. Ideally, the house supply connection should be in the shaded area shown in the above diagram. A means of isolation must be provided at the supply point by either an approved
The connector is located below the hotplate level at the rear of the cooker.
A flexible connection is supplied with the cooker, and it is with this in mind that the stability bracket and restraining chain have been supplied.
If it is necessary to use another hose, it must be to A.S. 1869 Class B standard and suitable for your gas type (if in doubt, contact your supplier). Even if you do use
26
