Australia

SERVICING - WARNING

Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.

Support the weight of the door and remove the screw nearest the hinge pin. Swing the hinge up and away from the hinge pin on the door.

Lift the door away from the bottom hinge. Re-assemble in reverse order.

When replacing the door, ensure that the nylon hinge bush is in position between the hinge pin and the hinge bracket at the both the bottom and top.

15. To Change the Main Oven Door Outer Panel

Remove the two plastic blanking plugs from the door handles. Remove the four 4mm Hex headed screws holding the handle to the door with the hexagon key tool. Remove two screws from the top edge, and two from the bottom edge, of the door:

Remove the outer door panel. Fit the door handle to the new panel. Fit the plastic blanking plugs to the fixing holes.

The handles should be above the fixings.

Fit the panel to the door. If replacing the outer panel on the right hand door (with the Thermodial) take care to make sure that the sensor of the Thermodial is sealed to the door by the rubber grommet:

16. To Change the Main Oven Door Catch

Remove the outer door panel (see section 15). Remove screws ‘B’ holding the catch assembly to the inner door panel. Fit the new catch and re-assemble in reverse order.

Verify that the door operation is correct.

17. To Adjust the Main Oven Door Catch Keep

Open the Main oven door, slacken off the locknut at the base of keep, and screw in or out as required until the required fit is obtained:

Retighten the locking nut.

18.To Replace the Tall Oven Door Outer Panel

Remove the oven door (see section 14). Lay the door face down on a suitable surface and remove the two screws from the bottom edge of door and the two screws from the inside face of the door.

Remove the outer door panel. Remove the door handle by unscrewing the two screws.

Remove the two cross-headed screws holding the door handle fixing bracket to the door panel. Fit the door handle bracket and the door handle to the new panel.

Fit the panel to the door and re-assemble in reverse order.

19. To Replace the Tall Oven Door Magnetic Latch

Remove the control panel (see section 2). Remove the plinth (three screws) and the central vertical cover (five screws). Prize the retaining clip off the magnet unit.

Fit the new unit and retaining clip, and re-assemble in reverse order. Verify that the door operation is correct.

20. To Change an Oven Door Seal

Open the oven door. The seal is held in place by small hooks on the rear face. At the corner, pull the seal diagonally away from the door centre until that hook is released. Proceed to

the next hook and release it in a similar way, and so on.

Re-assemble in reverse order.

32

Page 32
Image 32
Falcon U109635-02 manual To Change the Main Oven Door Catch