Australia
SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
Servicing Notes
Before servicing or replacing gas carrying components, disconnect the cooker from the gas supply, and check that the appliance is gas sound following completion.
Likewise, before servicing or replacing components that are connected to the electricity supply, particularly before removing the control panel, side panels, cooktop tray, or any of the electrical components or cover boxes, disconnect the cooker from this supply, and check that the appliance is electrically safe prior to reconnection.
CAUTION: DO NOT USE A FLAME TO CHECK FOR GAS LEAKS.
1. To Remove the Hand Rail
Remove the handrail plastic blanking plugs and remove the two end bracket fixing screws.
2. To Remove the Control Panel
Pull off all the control knobs. Remove the hand rail (see section 1) Remove the two cross headed screws that were hidden by the hand rail end brackets.
Open the grill door and right hand oven door and remove the two screws underneath the control panel.
Pull the control panel forward and support so that the wires are not strained.
3. To Remove the Hotplate Top
Remove the pan supports, cooktop burner caps and tops. If there are screws holding the cooktop burners to the cooktop, remove them (but not the spark electrode fixing screws).
A Cooktop front fixing screws
BCooktop rear fixing screws (on cooker back)
Remove the two rear cooktop fixing screws (B) on the cooker back under the flue grille, and the four front cooktop fixing screws (A).
Remove the screws holding the flue grille stays.
Lift the cooktop clear of the appliance. Replace in reverse order.
Check for correct burner operation.
4. To Remove a Side Panel
Remove the control panel (see section 2). Pull the cooker forward. Remove the four retaining screws from each panel (two at the front and two at the rear). The lower front retaining screws (one each side) are situated beneath the lower edge at the front corners of the side panels
5. To Replace the Main Oven Light Switch
Remove the control panel (see section 2).
NB The old switch may be destroyed during removal.
Remove the switch button and old switch from its bezel by gripping the switch body behind the control panel and twisting sharply.
The switch bezel can then be removed by folding back its locking wings and pushing forward. Fit the new bezel to the control panel by first lining up the raised key on its body with the cutout in the control panel and pushing it in from the front. Assemble the new switch to the bezel by lining up the key sections and pushing home. Fit the new button by pushing in from the front.
Replace the control panel and test for correct operation.
6. To Replace the Electronic Timer
Pull off the timer control buttons and remove the control panel (see section 2). Remove the timer/mounting bracket assembly from the control panel by removing the two fixing screws. Remove the timer from its mounting bracket by depressing the plastic lugs on the timer case, at the same time pulling the unit forward.
30
