To Adjust the Main Oven Door Angle, Top Element | Falcon U109635-02

Australia

SERVICING - WARNING

Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.

Remove the two screws B, holding the element to the bottom sheet.

Disconnect the leads, noting their positions.

Withdraw bottom element. Fit the new element and re- assemble parts in reverse order.

Top Element

Open the left hand oven door and undo the ﬁxings that secure the heat shield. Remove the top element bracket ﬁxings and withdraw the element.

Replace the element and re-assemble the parts in reverse order. Check that the oven operates satisfactorily.

24 To Adjust the Main Oven Door Angle

The Main Oven door bottom hinge can be adjusted to alter the angle of the door. Loosen the bottom hinge ﬁxing screws and use the notch and a ﬂat bladed screwdriver to move the position of the hinge to set the hinge position.

Retighten the hinge screws.

Eﬀect of hinge adjustment – exaggerated for clarity

Centre line of hinge pin

Oven door omitted for clarityCircuit Diagram

34

Image 34

Falcon U109635-02 manual To Adjust the Main Oven Door Angle, Top Element

Contents

User Guide for Australia Contents Before you start Cleaning This appliance is heavy, so take care when moving it Cooker Overview Hotplate Burners Griddle High/medium Wok CradleMedium/low Never close the grill door when the grill is on Glide-out Grill Left Hand Oven OvensRight Hand Tall Oven Clock Setting the time of dayTimer To stop the ovens at a specific time of day Auto is showing, but you want to revert to manual cooking Multi-Function OvenKey Lock Multi-Function Oven Functions Pre-heat this function before cooking Tips on Cooking with the Timer Handyrack Main Oven Oven Cooking chart Conventional and Fan Ovens Fish Oven Shelves General Oven TipsLeft Hand Main Oven Hotplate Burners Cleaning your CookerMain Oven Light Essential Information Main Oven GrillControl Panel and Doors Wok Cradle Troubleshooting Tall Oven Hotplate ignition or hotplate burners faulty Hotplate burners will not light Out of Warranty Service and SparesIf you have a problem Please note Installation Overhead Measurement a Side clearances Measurements B & C Lowering the Two Rear Rollers Unpacking the CookerMoving the Cooker Side clearances Measurement E Levelling Repositioning the Cooker following ConnectionConversion to LP Fitting the Handles and Front Handrail Fitting the Splashback Fitting the Stability Bracket Gas Connection Fitting the Restraining Chain Conversion from Natural Gas to LP Gas Pressure testing for Natural GasTap Adjustment Jets Electrical Connection Propane Pressure TestingStick on label Customer Care Oven CheckFitting the Plinth Thank you Servicing Notes To Change a Hotplate Tap To Replace a ThermostatTo Replace the Grill Controller To Replace a Hotpate Burner Jet To Change the Main Oven Door Catch To Replace an Oven Fan To Change Ignition GeneratorTo Remove an Oven Inner Back To Replace an Oven Fan Element To Adjust the Main Oven Door Angle Top Element Circuit Diagram Technical Data Australia Australia Australia