CM-1000A WIRING DETAIL
CONNECTOR 1
Pin 1 Red- Constant 12-volts (+) positive power input for the control module. This wire must be connected to a constant 12-volt (+) positive source. The proper wire will test 12-volt (+) positive with the key in the off position, while key is in the on position and during crank.
Pin 2 Violet- Parking light (+) positive output. Connect this wire to the (+) positive parking light wire generally at the parking light switch or behind the fuse box. The proper wire will test 12-volts (+) positive when the parking light switch is in the on position.
Pin 3 Brown- Siren 12-volts (+) positive output. This wire will provide a 30 or 60 second
(+) positive output for the external siren. (Note: Factory default is 30 seconds.)
Pin 4 Gray- Trunk release 12-volts (+) positive output. This wire will provide a (+) positive trigger pulse. (Note: Negative trigger trunk release will require a relay. System will unlock doors and disarm alarm prior to trunk release.)
Pin 5 Black- Ground (-) negative input. This wire will connect to chassis ground.
CONNECTOR 2
Pin 1 Yellow/Black- Normally closed pin (87a) of unlock relay. For a positive or negative unlock system this wire will not be used. For after-market actuators this wire will go to chassis ground. For reverse polarity this wire will go to the switch side of the unlock wire of the vehicle. When the factory unlock wire is cut the switch side will test 12-volts positive when the switch is pressed to unlock.
Pin 2 Yellow- Common pin (30) of unlock relay. For positive or negative unlock system this wire will go to the vehicles unlock wire. For after-market actuators this wire will go to the unlock wire of the actuator. For reverse polarity this wire will go to the motor side of the unlock wire of the vehicle.
Pin 3 Yellow/White- Normally opened pin (87) of unlock relay. For a positive unlock system this wire will go to a 12-volts (+) positive source. For a negative unlock system this wire will go to chassis ground. For after-market actuators this wire will go to a 12-volts (+) positive source. For reverse polarity this wire will go to a 12- volts (+) positive source.
- 40 -
