
Options Explained In Detail |
|
If enabled, this option will make the system unlock the doors before remote starting, start the vehicle, then lock the doors after the vehicle starts. It will then lock the doors again if the remote start run time expires and the vehicle shuts down. This feature is for vehicles that have factory alarms that need to be disarmed before remote starting.
This option determines the output duration of the door lock and unlock pulses. Some vehicles do not respond to short door lock/unlock pulses.
This option determines the minimum amount of crank time used when the system is operating in Alternator Sensing mode. The CompuStar system automatically increases its crank time if it fails to start during either the first or second attempts. This is how the CompuStar system will crank under the following conditions:
Option Setting | 1st Start Attempt | 2nd Start Attempt | 3rd Start Attempt |
|
|
|
|
Option | 0.8 sec | 0.9 sec | 1.0 sec |
Option | 1.0 sec | 1.1 sec | 1.2 sec |
If enabled, this option will cause the system to unlock the driver’s door first, and if the unlock button is pressed again within 3 seconds, the other doors will unlock. This option requires additional installation to function; you must isolate the driver’s door from the rest of the doors.
If enabled, this option will cause the system to double pulse the unlock output. This option is used on a majority of Chrysler vehicles. The first unlock pulse disarms the alarm, and the second pulse unlocks the doors.
If enabled, this option will cause the system to send a pulse to the vehicle through the dome light wire if:
a.The run time has expired and the vehicle shuts down.
b.The vehicle is shut down manually through the remote.
c.The system is locked and/or armed.
This option can be used to shut down the radio in vehicles where the radio stays on until the door opens after the ignition has been on. The system will also send
- 55 -