CM1000A

Option Menu 1

1

2

3

4

5

Feature

Factory Default

Lock/Unlock Pulse Duration

0.8 sec

Application of Pre-Wired Kill Relay

Starter Kill

Door Open Parking Light Indicator

Disabled

30 sec Passive Relock

Disabled

Double Pulse Unlock

Disabled

 

 

Optional

4 sec

Anti-Jacking (Ign Kill)

Enabled

Enabled

Enabled

These option descriptions are for the CM1000A ONLY. They differ from the regular option menus so much that they need their own section. The full listing of option menu descriptions immediately follows this page.

1.Lock / Unlock Pulse Duration

This option determines the output duration of the lock and unlock pulses Some Vehicles do not respond to short lock/unlock pulses.

2.Application of Pre-Wired Kill Relay

This option requires that the starter kill relay be installed in the ignition circuit, rather than into the starter circuit. With this option turned on, Panic mode will become Anti-Jacking mode. If Anti-Jacking is activated while the vehicle is running with the key in the ignition, the siren will sound for 30 seconds. After 30 seconds the system will break the ignition circuit, thereby disabling the vehicle. The siren will continue to play for 1 more minute. With this option turned off, when Panic mode is activated, the system will arm, activate the starter kill, and play the siren for 1.5 minutes.

3.Door Open Parking Light Indicator

With this option enabled, the parking lights will flash if a door is left open while the vehicle is being armed. This serves as a warning that all of the doors have not been closed.

4.30 sec Passive Relock

With this option enabled, after disarming the system with the remote, the system will relock the doors and arm the alarm after 30 seconds if a door has not been opened. At 10 and 20 seconds after the disarm command was given, the siren will chirp once to indicate that the alarm is about to rearm. At 30 seconds after, the siren will chirp once, and the system will arm the alarm. If you wish to stop this process, you must open a door within 30 seconds of disarming the alarm.

5.Double Pulse Unlock

With this option enabled, the unlock wire will perform a double pulse every time the unlock command is given. Some vehicles require this double pulse to operate the locks correctly.

- 54 -

Page 54
Image 54
Firstech, LLC CM3 SERIES, CM1000A, CM4200 manual Sec Anti-Jacking Ign Kill Enabled