US CA
16
Installation instructions
9. What to do if your product is unstable
AGently push the refrigerator back until the rear rollers contact the floor.
■■Measure the gap under the front foot, which has come off the floor.
■■Obtain some solid packing material (hardwood,
plastic, etc) which fits firmly into the gap under the foot.
Note: do not use metallic materials that may corrode, stain and/or damage floor coverings.
BWind both front feet up and roll the product out of position.
■■Place the packing material in the location diagonally opposite the front roller that lifts off the floor.
■■Make sure the packing material stays in place when the product is pushed back into position.
■■Ideally, the packing material is large enough to rest against the back wall so as to prevent it from moving when the cabinet is pushed into position.
Example only
Unlevel floor
This foot lifts off the floor when top front is gently pushed back
Fig 14.Unstable refrigerator
Wall behind refrigerator
Packing material goes under rear roller diagonally opposite front foot that lifts
Fig.15 Stabilizing your refrigerator
For example: if this foot lifts off the floor when pushing gently on the top front of the refrigerator
CRoll the refrigerator back into position and adjust front feet as per step 7C. (Check alignment and door closing action are satisfactory).
■■Make small adjustments to front feet where necessary.
■■Check that the product is stable (all 4 feet are on the floor). If not, repeat 9A and 9B.
