US 12 Installation instructions
CA
11Attach double sided foam to the back of the water filter head as shown in Diagram 5. Write the date to be replaced on the filter (date installed + 6 months). Remove double sided foam backing and attach filter to the desired position as located in step 10 (refer to previous page).
12Run the ¼/4” (6 mm) tubing to back of the refrigerator ensuring there is enough tubing to pull out the refrigerator for service.
13Remove compressor compartment cover by removing screw at the top of each side of the cover as shown in Diagram 6. Lift and tilt the compressor compartment cover to remove as shown in Diagram 7.
14Connect tubing into the water (solenoid) valve located on the right hand side of the unit (compressor) compartment as shown in Diagram 8. Beware of hot pipes.
15Pull gently on tubing to ensure it is locked in as shown in Diagram 9.
16Place compressor compartment cover back into position, run the ¼/4” (6 mm) tubing through the space provided at the top right hand side of the compressor compartment cover in an upward direction and rescrew the compressor compartment cover.
17The completed installation should look like Diagram 11 on page 13.
18Turn isolating faucet on and check that all connections are dry and free of drips.
19Coil water line tubing behind the refrigerator. Push your refrigerator into place being careful not to kink or squash the water line running into the water (solenoid) valve.
20Read pages 13 – 14 carefully and then turn refrigerator on.
Diagram 5
Fig.7 Double sided foam attachment
Diagram 6
Diagram 7
Diagram 8 | Diagram 9 |
