FOCUS Enhancements FS-2/2E manual Rear Connection Panel, Introduction

INTRODUCTION

Rear Connection Panel

The FS-2/2E rear panel, shown below, contains control /audio/video input/output areas described in this section.

You can select any of the available inputs as a source. When selected, that source is what is recorded to disk. If the unit is in E-E mode or recording, all outputs are live with the incoming signal.

For any particular video input, there is an associated audio input selected as a default. You can change that default to another input utilizing the AUDIO INPUT MENU under SETUP. Refer to Chapter 2 for more information.

1 5 7 9 11 13 15 17 20

	3 4	6	8	10	12	14	16	18
									19
2

1GPI : For connection of the optional wired remote control (ACSS-0019-01), the optional RS232C cable (CBLA-

0114-01) or contact closure cable. The GPI plug accepts a 3.5mm TRS connector.

2Ethernet 10/100 BaseT - For connecting FS-2/2E to a network or computers for file exchange, telnet, or web control. (The web control functionality is only available for the FS-2E or the FS-2 with the 2.0 upgrade.)

3To Computer: For connecting the FS-2/2E to a computer's FireWire 400 port. It allows any disk drives connected to the FS-2/2E to mount to the computer.

4To HDD : For connecting external FireWire 400 disk drives to the FS-2/2E. Use the FS-2/2E's HDD Bypass function with this port. When a connection is made with "Front Panel HDD Port Loop Through", it allows the front panel FireWire connector to be used for connection of external FireWire HDDs.

5Front Panel HDD Port Loop Through: When patched to the "To HDD" port, this connector activates the front panel FireWire port for connection of external HDDs.

6DV I/O 1 and DV I/O 2: For connection of DV video devices. These two ports are used to pass through the DV signal. The FS-2/2E does not support multiple DV inputs.

7RS422 Control: This is the input connector for external RS422 control devices.

8SDI Input : For connecting SDI input sources. The FS-2E provides the selection of channels 1 and 2 or 3 and 4 of the embedded SDI audio. Refer to the AUDIO INPUT->SDI->EMBEDDED sub-menu on “Audio Input” on page 2-22. The FS-2 does not have this capability.

SDI Output: For output to SDI devices. The FS-2E inserts two channels of audio into the SDI output stream. Only the FS-2E has this capability.

9Y/C Input: For connecting Y/C (S-Video) input sources.

Y/C Output: For connecting to Y/C (S-Video) devices.

10Video Monitor Output: For connection to a video monitor (composite). You can view the On Screen Display from this connection.

11Composite / Y input: For connecting composite input sources or the Y signal for component input sources.

Composite / Y Output: For output to composite devices or the Y signal to component devices (select either composite or component form ANALOG SETTINGS in the SETUP MENU).

FS-2 and FS-2E Studio DTE Disk Recorders User Guide

1 - 6

Part Number: MANL-0927-03