FOCUS Enhancements FS-2/2E manual Formatting the Drive, Setting the Time and Date

INTRODUCTION

To set up the FS-2/2E, do the following: STEP 1: Plug in the power cord.

STEP 2: Connect a Video input device.

STEP 3: Connect an Audio source (if desired).

STEP 4: Connect a Monitor if desired.

STEP 5: Connect Speakers or Headset (to monitor the audio) if desired.

STEP 6: Connect a Tape Drive if desired.

STEP 7: Connect a Time Code Generator if desired.

STEP 8: Connect an External Control Device

(RS422) Device if desired.

STEP 9: Connect a Reference Video signal if desired.

Formatting the Drive

Use this procedure to format the FS-2/2E internal or connected external disk drives when not yet formatted.

STEP 1: From the Utilities Menu, select FORMAT DISK as shown below.

When you make this selection, the fol- lowing screen appears:

FORMAT DISK
VOLUME 1?		:
SIZE		115GB
FREE		540 MIN
EXIT	YES	NO

STEP 2:	Select between volumes by pressing
	the	and	buttons.

•When you select the volume and press YES, the following screen appears:

FORMAT WILL

ERASE ALL DATA!! :

CONTINUE FORMAT

VOL 1?

EXITYES NO

•When you select YES, a message indicating that the formatting is progressing appears.

STEP 3: Press EXIT to return to the menu screen.

WARNING: FORMAT ERASES ALL DATA ON THE DISK DRIVE!

Setting the Time and Date

Before using the FS-2/2E, use this procedure to set the time and date.

STEP 1: Select the Setup Menu.

STEP 2: Select SET DATE & TIME. The following screen appears.

SET DATE

SET TIME

EXITSEL

STEP 3: Select SET DATE or SET TIME and press SEL to open the sub menu as shown below.

SYSTEM DATE

02/24/02

MM/DD/YY

&

MOVES CURSOR

EXIT

SYSTEM TIME 16:21:13 Hh:Mm:Ss

&

MOVES CURSOR

EXIT

FS-2 and FS-2E Studio DTE Disk Recorders User Guide

1 - 9

Part Number: MANL-0927-03