FOCUS Enhancements FS-2/2E Reference, Technical Specifications, Input/Outputs, Balanced Inputs

Reference

CHAPTER 4

REFERENCE

This chapter contains reference information for the FS-2/2E as follows:

Technical Specifications FS-2/2E LCD Display Modes Supported RS422 Commands Shuttle Speed Parameters Jog Speed Parameters Custom Commands

Technical Specifications

Input/Outputs

Component - Y, Pr, Pb (3 x BNC in, 3 x BNC out)

if Component SMPTE:

•100% white at 700mv with 300mv Sync

•700mv Chroma levels (100% color bars)

•Setup default to OFF

•Chroma offset default to OFF

If Component Betacam

•100% white is at 714mv with 286mv Sync

•4/3 Chroma boost to 934mv p to p

•Setup default to ON

If Component MII:

•100% white is at 700mv with 300mv Sync

•Black to White range is restricted to 647mv (700-setup)

•Setup is ON

Sync (1 x BNC in, 1 x BNC out) Composite (1 x BNC in, 1 x BNC out) Monitor Video Out - Composite (1 x BNC) General Composite Specifications

Differential Phase 2 Degree maximum

Differential Gain	2% maximum
Hue Accuracy	1 Degree
Signal/Noise Ratio	Greater than 54 dB
Bandwidth	5.5 MHz
K Factor % @ 2T	1 % maximum
Y/C Delay	Less than 25 nS
Subcarrier locking range		100Hz

Subcarrier free-run frequency +/- 30 Hz (NTSC or

	PAL Fsc deviation
Genlock Horizontal
adjustment range	+ 4 uS
Residual Subcarrier	Less than 0.5 IRE
SC Phase	Less than 2 degrees

S-Video - Y/C (1 x 4-pin DIN in, 1 x 4-pin DIN out) Levels Adjustments

Video Gain	- +/- 20% 2mv resolution
Chroma Gain	- +/- 20% 2mv resolution
Setup	ON adds 7.5 IRE, or 53mv to
	luminance channel
	OFF no change to luminance
	channel

Serial Digital - SD-SDI (1 x BNC in, 1 x BNC out) - conforms to the SMPTE 259M standard

The FS-2E outputs embedded audio in the SDI output stream. This feature is only available for the FS-2E.

Timecode (1 x BNC in, 1 x BNC out)

Balanced Audio (2 x XLR in, 2 x XLR out) Stereo Audio Monitor (1 x 1/4” TRS jack)

General Audio Specifications

Balanced Inputs
Input Impedance	600 Ohms +/-10
Ohms
Quantization	16 bits 48Khz

Common mode rejection @1 KHz (dB)100 dB

Analog Input adjustment range -34dB to +4.5dB (in 1.5dB steps, default setting 0dB)

Amplitude with no clipping 3.5Vp-p

FS-2 and FS-2E Studio DTE Disk Recorders User Guide

4 - 1

Part Number: MANL-0927-03