Fortinet 5001A-DW, 5001A-SW manual Removing a FortiGate-5001A board

Removing a FortiGate-5001A board Hardware installation

10Once the board is inserted correctly, fully tighten the retention screws to lock the FortiGate-5001A board into position in the chassis slot.

Retention

Screw

Tighten

Removing a FortiGate-5001A board

The following procedure describes how to correctly use the FortiGate-5001A mounting components described in “FortiGate-5001A mounting components” on page 14 to remove a FortiGate-5001A board from an ATCA chassis slot.

FortiGate-5001A boards are hot swappable. The procedure for removing

a FortiGate-5001A board from a chassis slot is the same whether or not the chassis is powered on.

To remove a FortiGate-5001A board from a chassis slot

Caution: Do not carry the FortiGate-5001A board by holding the handles or retention

! screws. When inserting or removing the FortiGate-5001A board from a chassis slot, handle the board by the front panel. The handles are not designed for carrying the board. If the handles become bent or damaged the FortiGate-5001A board may not align correctly in the chassis slot.

To complete this procedure, you need:

• An ATCA chassis with a FortiGate-5001A board installed

• An electrostatic discharge (ESD) preventive wrist strap with connection cord

Caution: FortiGate-5001A boards must be protected from static discharge and physical ! shock. Only handle or work with FortiGate-5001A boards at a static-free workstation.

Always wear a grounded electrostatic discharge (ESD) preventive wrist strap when handling FortiGate-5001A boards.

1 Attach the ESD wrist strap to your wrist and to an available ESD socket or wrist strap terminal.

2 Disconnect all cables from the FortiGate-5001A board, including all network cables, the console cable, and any USB cables or keys.

	FortiGate-5001A Security System Guide
18	01-30000-83456-20081023