Quick Configuration Guide |
Where <name_str> is the name of the firmware image file and <tftp_ipv4> is the IP address of the TFTP server. For example, if the firmware image file name is image.out and the IP address of the TFTP server is 192.168.1.168, enter:
execute restore image image.out 192.168.1.168
The
This operation will replace the current firmware version!
Do you want to continue? (y/n)
6Type y.
The
7Reconnect to the CLI.
8To confirm the firmware image is successfully installed, enter:
get system status
9Update antivirus and attack definitions. You can use the command execute
FortiGate-5001A base backplane data communication
This section describes how to configure
Note: Different
By default the base backplane interfaces are not enabled for data communication. Once the base backplane interfaces are configured for data communication you can operate and configure them in the same way as any
Note: The
Note: The
Although not recommended, you can use base backplane interfaces for data communication and HA heartbeat communication at the same time.
| |
34 |
