Inserting a | Hardware installation |
1Attach the ESD wrist strap to your wrist and to an available ESD socket or wrist strap terminal.
2If required, remove the protective metal frame that the
3Insert the
4Unlock the handles by squeezing the handle locks.
Unlock Handle
5
!
Open the handles to their fully open positions.
Caution: To avoid damaging the lock, make sure you squeeze the handles fully to unlock them before opening. The handles should pop easily out of the board front panel.
Alignment Pin
Open Handle
Lock
Alignment Pin
Handle
6
7
8
Insert the
Insert the board by applying moderate force to the front faceplate (not the handles) to slide the board into the slot. The board should glide smoothly into the chassis slot. If you encounter any resistance while sliding the board in, the board could be aligned incorrectly. Pull the board back out and try inserting it again.
Slide the board in until the alignment pins are inserted half way into their sockets in the chassis.
| |
16 |