Configuring Transparent mode | Quick Configuration Guide |
4Type admin in the Name field and select Login.
To switch from NAT/Route mode to transparent mode
1Go to System > Status and select the Change link beside Operation Mode: NAT.
2Set Operation Mode to Transparent.
3Set the Management IP/Netmask to the settings that you added to Table 9 on page 31.
4Set the default Gateway to the setting that you added to Table 9 on page 31.
To change the admin administrator password
1Go to System > Admin > Administrators.
2Select Change Password for the admin administrator and enter the password that you added to Table 9 on page 31.
To change the management interface
1Go to System > Config > Operation.
2Enter the Management IP address and netmask hat you added to Table 9 on page 31 and select Apply.
To configure the Primary and Secondary DNS server IP addresses
1Go to System > Network > Options.
2Enter the Primary and Secondary DNS IP addresses that you added to Table 9 on page 31 as required and select Apply.
Using the CLI to configure Transparent mode
1Use the serial cable supplied with your
2Start a terminal emulation program (HyperTerminal) on the management computer. Use these settings:
Baud Rate (bps) 9600, Data bits 8, Parity None, Stop bits 1, and Flow Control None.
3At the Login: prompt, type admin and press Enter twice (no password required).
4Change from NAT/Route mode to Transparent mode. Configure the Management IP address and default gateway to the settings that you added to Table 9 on page 31.
config system settings set opmode transparent
set manageip <mng_ip>/<netmask> set gateway <gateway_ip>
end
5Configure the primary and secondary DNS server IP addresses to the settings that you added to Table 9 on page 31.
config system dns
set primary
| |
32 |
