Configuring NAT/Route mode | Quick Configuration Guide |
3Set the addressing mode for the interface. (See the online help for information.)
•For manual addressing, enter the IP address and netmask for the interface that you added to Table 8 on page 29.
•For DHCP addressing, select DHCP and any required settings.
•For PPPoE addressing, select PPPoE and enter the username and password and any other required settings.
To configure the Primary and Secondary DNS server IP addresses
1Go to System > Network > Options.
2Enter the Primary and Secondary DNS IP addresses that you added to Table 8 on page 29 as required and select Apply.
To configure the Default Gateway
1Go to Router > Static and select Edit icon for the static route.
2Select the Device that you recorded above.
3Set Gateway to the Default Gateway IP address that you added to Table 8 on page 29.
4Select OK.
Using the CLI to configure NAT/Route mode
1Use the serial cable supplied with your
2Start a terminal emulation program (HyperTerminal) on the management computer. Use these settings:
Baud Rate (bps) 9600, Data bits 8, Parity None, Stop bits 1, and Flow Control None.
3At the Login: prompt, type admin and press Enter twice (no password required).
4Change the administrator password.
config system admin edit admin
set password <password>
end
Note: See the Fortinet Knowledge Center article Recovering lost administrator account passwords if you forget or lose an administrator account password and cannot log into your FortiGate unit.
5Configure the port1 internal interface to the setting that you added to Table 8 on page 29.
config system interface edit port1
set ip <intf_ip>/<netmask_ip>
end
| |
30 |
