INSTALLATION MANUAL

7.INSTALLATION MANUAL

7.1NOTICES FOR INSTALLATION

Important Notices

The unit installation work must be done by qualified personnel according to the local rules and this manual.

Before installating, please contact with local authorized maintenance center, if unit is not installed by the authorized maintenance center, the malfunction may not solved, due to discommodious contacts.

When removing the unit to the other place, please firstly contact with the authorized Maintenance Center in the local area.

T he appliance must be positioned so that the plug is accessible

After pull out the power plug then make the appliance operation againto avoid the icing of outdoor unit damage axial flow fanshould electrify the appliance but not operation for 4 hours for warm-up purpose(only for Heat Pump models).

Basic Requirements For Installation Position

Install in the following place may cause malfunction. If it is unavoidable contact with service center please:

Place where strong heat sources, vapors, flammable gas or volatile object are emitted.

Place where high-frequency waves are generated by radio equipment, welders and medical equipment.

Place where a lot of salinities such as coast exists.

Place where the oil (machine oil) is contained in the air.

Place where a sulfured gas such as the hot spring zones is generated. Other place with special circumstance.

Indoor Unit Installation Position Selection

The air inlet and outlet vent should be far from the obstruction, make sure that the air can be blown through the whole room.

Select a position where the condensing water can be easily drained out, and the place

is easily connected for outdoor unit.

Select a location where the children can not reach.

Can select the place where is strong enough to withstand the full weight and vibration of the unit. And will not increase the noise.

Be sure to leave enough space to allow access for routine maintenance. The height of the installed location should be 8ft or more from the floor.

Select a place about 1m or more away from TVset or any other electric appliances.

Select a place where the filter can be easily taken out.

Make sure that the indoor unit installation should accord with installation dimension diagram requirements.

Do not use the unit in the immediate surroundings of a laundry a bath a shower or a swimming pool.

36

Page 36
Image 36
Friedrich MW12C1H, MW09C1H, MR09C1H, MR12C1H manual Important Notices