Installation Manual
7.3InstallingIndoorUnitInstalling Mounting Plate
1.Make the mounting plate completely level . As the water tray's oulet of the indoor unit is
2.Fix the mou ting plate n the wall with screws.(Where is
3.Be sure that the mounting plate has been fixed firmly enough to withstand the weight of an adult of 60kg; further more, the weight should be evenly shared by each screw.
Wall | Wall |
Mark on the middle of it | Gradienter |
Space | Space |
to the | to the |
wall | wall |
6 in | 6 in |
above | above |
Left |
|
|
|
| Right |
| |
2.5 in |
|
| Fig.5 |
| 2.5 in |
| |
|
|
| |||||
(Rear piping hole) | (Rear piping hole) |
| |||||
|
| ||||||
|
|
| Boring Piping Hole |
|
|
|
|
|
|
|
|
| Indoor |
| Outdoor |
|
|
|
|
|
| ||
1.Make the piping hole (2.5 in) in the wall at a slight downward slant to the | Wall pipe | Seal pad | |||||
outdoor side. |
|
|
|
| |||
|
|
|
|
| |||
2.Insert the |
|
|
| ||||
and wiring from being damaged when passing through the hole. |
|
|
| Ø55 | |||
|
|
|
| ||||
|
|
| Installing Drain Hose |
|
|
|
|
1.For proper draining, the drain hose should be placed at a downward slant. Wrenched | Bent | ||||||
2.Do not wrench or bend the drain hose or flood its end by water.
3.The long drain hose passing through indoor areas should be wrapped with insulation material.
Flooded
Connecting Indoor and Outdoor Electric Wires
1.Open the front panel.
2.Remove the wiring cover as shown in Fig 6.
3.Make the power connection cord and signal control wire (onlyl ffororheatheatpumppumpunit)unitthrough) throughthe theholeholein thein the the back of indoor unit.
4.Reinstall the clamp and wiring cover.
5.Recovert he front panel.
Fig.6
39
