Remote Control Operation
Remote Control - Refer to Figures 10 and 11 during operation description.
Getting Started - Install two (2) AAA batteries in the battery compartment located on the back of the unit.
Operation - The remote control should be within 25 feet of the air conditioner for operation. (Refer to Figure 9 for effectiveness). Press the power button to turn the remote on. The remote will automatically power off after 15 seconds if the buttons are not being pressed. The remote must be on to control the unit.
POWER Button - Turns remote and unit on and off.
SYSTEM Button - Allows the user to sequentially select, Cool 
, HEAT 
, and FAN ONLY 
operation. When the button is pressed, the display indicates which mode has been selected via a display message. Note that when the heating function is not available, the system will automatically skip the HEAT mode.
FAN MODE Button - Selects between automatic ( AUTO FAN ) or CONTINUOUS operation. In the AUTO FAN mode, the fan only turns on and off when the compressor operates or the heat function is enabled.
NOTE: |
|
| is not available in the FAN ONLY Mode, the display | |||
AUTO FAN | ||||||
| indicates |
|
| . In the |
| mode, fan speed is |
|
| CONTINUOUS | CONTINUOUS | |||
| determined | by your | selection on the SPEEDFAN | button. | ||
FAN SPEED Button - Used to sequentially select new fan speed, plus AUTO operation. When the SPEEDFAN button is pressed, the fan speed icon (triangle) changes to indicate the new speed level. Fan speed automatically varies depending on the set temperature on the control panel and the actual room temperature. For example if there is a big difference between your set temperature and the actual room temperature, the system fan speed increases to HIGH. It remains at this speed until the room temperature matches the set temperature.
SCHEDULE Button – The SCHEDULE button turns the schedule function on and off. Press the Schedule button once to turn on the Schedule (Residential, Commercial, Timer, or Customized) that has already been selected on your unit. Pressing the SCHEDULE button a second time turns the schedule function off.
UP and DOWN Arrows - Pressing either the 
(UP) or 
(DOWN) button changes the desired room temperature. The factory preset lower and upper limits are 60°F (16°C) and 99°F (37°C). These buttons are also used to navigate between function options when using the User Menu or Maintenance Mode.
Remote Effectiveness
Hand Held Remote - Has an operating range of up to 25 ft. The infrared remote control signal must have a clear path to transmit the command to the air conditioning unit. The remote signal has some ability to "bounce" off of walls and furniture similar to a television remote control. The diagram below shows the typical operating range of the control in a standard room with 8 ft high ceilings.
Figure 9 |
|
|
| TOP VIEW |
|
|
|
| |
|
| 25ft |
|
|
|
| 25ft |
|
|
| 7.5ft |
|
|
|
SIDE VIEW |
| 4ft | 60° | 60° |
45° | 30° |
| 6ft | |
|
|
| ||
|
|
|
| |
| 60° | 8ft | 45° | 45° |
|
| |||
|
| 25ft |
|
|
| 60° |
| 30° | 30° |
| 45° |
| ||
|
| 30° |
|
|
|
|
|
| 16ft |
| 8ft |
|
|
|
|
| 25ft |
|
|
|
| 25ft |
| 25ft |
|
| 25ft |
| 25ft |
|
|
|
| |
|
|
|
| FRR080 |
|
|
|
| 19 |
