Figure 24
| FRONT EDGE OF LOUVERS |
|
| MUST ALWAYS BE OUTSIDE OF |
|
| EXTERIOR WALL SURFACE. | 3/4” MINIMUM FRONT |
|
| |
|
| EDGE OF CABINET TO |
|
| INSIDE WALL SURFACE. |
3/4” MINIMUM |
| TRIM AROUND THE |
|
| |
|
| CABINET WITH A |
CABINET FRONT |
| SUITABLE WOOD |
| MOULDING AND | |
|
| |
|
| FINISH TO SUIT. |
1” THICK LUMBER |
| CAULK ALL AROUND |
| CABINET ON OUTSIDE | |
|
| |
|
| TO INSURE A WEATHER |
|
| TIGHT SEAL. |
1” MINIMUM | 1/4” SLOPE DOWN. |
|
|
| |
INSIDE WALL | POSITION AND SECURE |
|
| CABINET DOWNWARD. |
|
EXTERIOR WALL | SLOPE OUTSIDE FOR |
|
DRAINAGE. |
| |
|
| |
MAX. WALL | 7/8” SLOTTED HEAD SCREWS (3 EA. SIDE) |
|
THICKNESS | NAILS MAY BE USED IF DESIRED. |
|
ALLOWED | FRR092 | |
|
| |
STEP 7. Cut two pieces of standard 1" lumber (supplied by installer) to the length and width required. Place in front and back of bottom sill channel as shown in Figure 24. Secure with nails (supplied by installer).
STEP 8. Seal all holes in the cabinet with caulking compound (supplied by installer).
STEP 9. Complete the installation by following STEPS 6 through 11 of Standard Window Installation (Page 24). Window Seal Gasket mentioned in STEP 9 will not be required.
IMPORTANT: Before operating your unit, read STEP 11 of Standard Window Instructions.
Figure 25
SOLID MASONRY CONSTRUCTION | CAULK ALL SIDES |
|
CABINET
MORTAR 
|
| ELECTRICAL |
|
| RECEPTACLE |
NOTE: ELECTRICAL RECEPTACLE LOCATION |
|
|
FROM POINT “X” MUST BE WITHIN A MAXIMUM |
|
|
RADIUS OF 69” FOR 115V UNITS. | POINT “X” | FRR093 |
|
|
29
