Troubleshooting |
| ENGLISH | |
During operation |
|
|
|
|
|
|
|
Problems | Possible Causes | Solutions | Page |
The shutter cannot be re- | a Does “j” blink on the LCD? | a Replace the battery. | 13 |
leased. | b Does the power turn on? | b Press the POWER button. | 12 |
| c Does “f” blink on the LCD? | c The flash is charging. Wait until “f” stops blinking | 24 |
|
| (the flash takes about 7 seconds to charge). |
|
| d Is “E” showing on the counter? | d Take out the film, and load a new roll of film. | 18 |
After loading the film and clos- | d Is the film pulled out of the cassette | d Adjust the film length so that the green mark is in | 18 |
ing the back, “E” blinks. | far enough? Is it pulled out to far? | the camera correctly, and close the back. |
|
After loading the film and clos- | d Did you try to take out the film with- | d Check that the motor has stopped and that “E” is | 29 |
ing the back, the film is re- | out checking that the motor has | showing on the counter. After that, open the back |
|
wound and “E” is showing on | stopped and that “E” is showing on | and take out the film. |
|
the counter. | the counter? |
|
|
The film is rewound while tak- | d Did you slide the back lock while | d Do not slide the back lock while the partially used | 29,31 |
ing pictures. | the partially used film was loaded? | film is loaded. |
|
The counter blinks. | d Did you take out the partially used | d After taking out the film, remove the battery, | 29 |
| film without rewinding? | press the POWER button, and check that the |
|
|
| counter is no longer shown. Then load the bat- |
|
|
| tery again. |
|
The | d Is the date change mode on? | d Cancel the date change mode. | 14 |
“q” blinks and the shutter can- | d The camera is broken. | d Please contact a FUJIFILM authorized distributor. |
|
not be released. |
|
|
|
45
