Fujitsu C141-E090-02EN manual Information to be read by Identify Device command 4

Table 5.5 Information to be read by IDENTIFY DEVICE command (4 of 4)

*17	Word 85:	Enable/disable Command set/feature enabled
	Bit 15:	Reserved
	Bit 14:	NOP command supported = 0
	Bit 13:	READ BUFFER command supported = 0
	Bit 12:	WRITE BUFFER command supported = 0
	Bit 11:	Reserved
	Bit 10:	Host Protected Area feature set supported = 0
	Bit 9:	DEVICE RESET command supported = 0
	Bit 8:	SERVICE interrupt enabled = 0
	Bit 7:	Release interrupt enabled = 0
	Bit 6:	Look-ahead enabled = 1
	Bit 5:	Write cache enabled = 1
	Bit 4:	PACKET Command feature set supported = 0
	Bit 3:	Power Management feature set supported = 0
	Bit 2:	Removable Media feature set supported = 0
	Bit 1:	Security Mode feature set enabled = 1
	Bit 0:	SMART feature set enabled = 1
*18	Word 86:	Enable/disable Command set/feature enabled
	Bit 15-5:	Reserved
	Bit 4:	Removable Media Status Notification feature set enabled = 0
	Bit 3:	Advanced Power Management feature set enabled = 1
	Bit 2:	CFA feature set supported = 0
	Bit 1:	READ/WRITE DMA QUEUED command supported = 0
	Bit 0:	DOWNLOAD MICROCODE command supported = 0
*19 Word 88: Ultra DMA modes
	Bit 15-13: Reserved
	Bit 12-8: Currently used Ultra DMA transfer modes
	Bit 7-5:	Reserved
	Bit 4-0:	Supportable Ultra DMA transfer mode
		Bit 4=1 Mode 4
		Bit 3=1 Mode 3
		Bit 2=1 Mode 2
		Bit 1=1 Mode 1
		Bit 0=1 Mode 0

*20 Word 89: Time required for SECURITY ERASE UNIT command to complete MPE3102AH: X’0009’ (18 minutes)

MPE3136AH: X’000C’ (24 minutes)

MPE3204AH: X’0012’ (36 minutes)

MPE3273AH: X’0018’ (48 minutes)

*21 Word 93: CBLID– detection results Bit 15-14: Reserved

Bit 13: Device detected CBLID– above VIH (80-conductor cable) = 1 Device detected CBLID– below VIL (40-conductor cable) = 0

Bit 12-0: Reserved

C141-E090-01EN 5 - 33