Fujitsu M4097D manual Contents of the Setup Mode

Contents of the Setup Mode

This section describes the contents of the setup mode.

No	Item	Description	Selectable	Default
			parameters
		Specifies the double feed detection.
1	Double feed check	Double feed is detected by checking the		No
		document length and/or paper thickness.**
	Length check	Specifies the document length to enable	Tolerance:
2		double feed detection sets the document		No
	=No/10/15/20 mm		No/10/15/20mm
		length.
		Scanner automatically sets the	Document:
			No
		recommended reading parameters. 3 sets
3	IPC pre-setting		Sharpen Darken	No
		of parameters are available when IPC-4D
			Charactor Copy
		is not installed.
			Quality
4	Resetting of	Resets the abrasion counter.	-	-
	abrasion counter
		Specifies the time from document
5	Pick start time	Insertion to the start of picking. User can	Time:	1.0 sec
	setting	select the most comfortable Pick start time	0.2 to 29.8 sec
		for the job.
	Time-out limit	Specifies the time the scanner waits for	Time:
6		the next document insertion after the last	27 values from	30 sec
	setting
		document was scanned.	1 to 1999 sec
	ADF front offset	Specifies the horizontal and vertical offset	Offset:	Offset:
7		of the front side image when using the	H:-2 to +3 mm	H: 0 mm
	setting*
		ADF.	V:-2 to +3 mm	V: 0 mm
	ADF back offset	Specifies the horizontal and vertical offset	Offset:	Offset:
8		of the back side image when using the	H:-2 to +3 mm	H: 0 mm
	setting*
		ADF.	V:-2 to +3 mm	V: 0 mm
	Flatbed offset	Horizontal and vertical offset of the FB	Offset:	Offset:
9			H:-2 to +3 mm	H: 0 mm
	setting*	image is specified.
			V:-2 to +3 mm	V: 0 mm

7-2