Fujitsu MAU3036NC/NP, MAU3073NC/NP, MAU3147NC/NP manual Task

Task		Alert message	Page
Mounting Installation	Damage
	1.	Be careful of the insertion orientation of the SCSI connectors.	5-12
		With the system in which terminating resistor power is supplied
		via the SCSI cable, if the power is turned on, the overcurrent
		protection fuse of the terminating resistor power supplier may
		be blown or the cable may be burnt if overcurrent protection is
		not provided.
		When the recommended parts listed in Table 4.2 are used,
		inserting the cables in the wrong direction can be prevented.
	2.	To connect SCSI devices, be careful of the connection position
		of the cable. Check that the SCSI device with the terminating
		resistor is the last device connected to the cable.
	Data loss
	When the SEND DIAGNOSTIC command terminates with the		6-4
	CHECK CONDITION status, the INIT must collect the error
	information using the REQUEST SENSE command. The RECEIVE
	DIAGNOSTIC RESULTS command cannot read out the error
	information detected in the self-diagnostics.
	Caution
	1.	To avoid shocks, turn off the power before connecting or	6-5
		disconnecting a cable, connector, or plug.
	2.	To avoid injury, do not touch the mechanical assembly during
		disk drive operation.
	3.	Do not use solvents to clean the disk drive.
	Caution
	1.	Always ground yourself with a wrist strap connected to ground	6-6
		before handling. ESD (Electrostatics Discharge) may cause
		the damage to the device.
	2.	To prevent electrical damage to the disk drive, turn the power
		off before connecting or disconnecting a cable, connector, or
		plug.
	3.	Do not remove a PCA. This operation is required to prevent
		unexpected or unpredictable operation.
	4.	Do not use a conductive cleaner to clean a disk drive assembly.
	5.	Ribbon cables are marked with a colored line. Connect the
		ribbon cable to a cable connector with the colored wire
		connected to pin 1.
	Damage
	Never open the disk enclosure in the field. Opening the disk		6-6
	enclosure may cause an irreparable fault.
	Data loss
	Save data stored on the disk drive before requesting repair. Fujitsu		6-7
	does not assume responsibility if data is destroyed during servicing
	or repair.

vi C141-E205