Contents
Main
Page
Warranty and Disclaimer
0Contents
Page
1Overview
1.1 Abstract
1.2 Features
This board must only be used for test applications in an evaluation laboratory environment.
Page
1.3.8 I2C Bus
1.3.9 Emulator System
2Installation
2.1 Connection/Power-On
Fujitsu Microelectronics Europe GmbH - 11 - FMEMCU-UG-960014-10
2.2 Default Jumper settings for MB96370 Series
FMEMCU-UG-960014-10 - 12 - Fujitsu Microelectronics Europe GmbH
Jumper Description / Function Type Default Setting Coordinates
Table 2-1: Jumper Settings
Page
3Jumpers and Switches
3.1 Operating Mode (S1)
3.2 Power Supply (S2, JP: 8, 15, 16, 17, 22)
3.3 Subclock (JP: 1, 2)
3.4 Analog Power Supply Voltage (JP: 11, 12, 13, 14)
3.5 Alarm Comparator (JP: 85)
3.6 Reset Generation (JP: 33, 41, 46, 47, 48)
3.7 User Buttons SW1, SW2, SW3, SW4, SW5, SW6 (JP: 3, 4, 5, 6, 7)
3.8 I2Cpull-up resistor (JP: 9, 10)
3.9 LIN / UART
3.9.1 LIN-UART 0 (JP: 19, 21, 23, 25, 27, 28, 29, 31)
3.9.2 LIN-UART 2 (JP: 36, 37, 38, 39, 40, 42, 43, 45)
3.10 CAN interfaces (JP: 24, 26, 34, 35)
3.11 External Flash memory (JP: 49, 52, 56)
3.12 External SRAM memory (JP: 50, 53, 59)
3.13 Graphic Display Controller interface (JP: 54, 55, 56, 57, 58, 60, 85, 86)
4Connectors
4.1 Power connector (X7)
4.2 MCU pin header connectors (X20A, X20B, X21, X22 and X23)
4.3 LIN-UART connectors (X5, X9)
4.4 CAN Connector (X6, X8)
4.5 USER-LEDs & optional LC-Display (J1)
4.6 In-Circuit-Programming Connector (X4)
Page
5Programming the internal Flash memory
5.1 Asynchronous Mode
5.1.1 Uart0
5.1.2 Uart2
5.1.3 Reset (optional)
5.1.4 Flash Programming
5.2 Synchronous Mode
6Appendix
6.1 Related Products
7Information in the WWW
8China-RoHS regulation Evaluation Board Emulation Board
Page
9Recycling
