Fujitsu MB96300 manual Synchronous Mode, Flash Programming Socket

SK-96370-144PMC-GDC User Guide

Chapter 5 Programming the internal Flash memory

4)After programming the Flash-device, switch off the power supply and set back the mode according to the usage of the application, e.g.:

DIP-Switch S1

(RUN Mode)

MD0 MD1 MD2 nc

ON

OFF

1 2 3 4

5)Power on the board. The user application is started directly.

5.2Synchronous Mode

In order to program the Flash-ROM synchronously special third-party soft- and hardware has to be used, e.g. GALEP-4 from www.conitec.de. This tool is not available for free.

A dedicated Flash programming socket (X4) is provided on the evaluation-board for direct connection to this programmer.

X4: Flash programming socket

n/c 1 MD0 3 RST 5

SOT3 7

VCC 9

2n/c

4n/c

6SIN3

8SCK3

10GND

Figure 5-1: Flash Programming Socket

© Fujitsu Microelectronics Europe GmbH - 31 - FMEMCU-UG-960014-10