Fujitsu MB96300 manual LIN-UART 2 JP 36, 37, 38, 39, 40, 42, 43, Can interfaces JP 24, 26, 34

			SK-96370-144PMC-GDC User Guide
			Chapter 3 Jumpers and Switches
3.9.2 LIN-UART 2 (JP: 36, 37, 38, 39, 40, 42, 43, 45)
Jumper		Setting		Description
JP37		1-2		SIN2 is connected to RS232 transceiver
(RXD)	2-3			SIN2 is connected to LIN transceiver
JP39	1-2			SOT2 is connected to RS232 transceiver
(TXD)	2-3			SOT2 is connected to LIN transceiver
JP40		1-2		X9 pin 2 is connected to RS232 transceiver
(RS232/LIN)	2-3			X9 pin 2 is connected to LIN transceiver
JP36		Closed		RTS and CTS of X9 are connected
(RTS-CTS)		Open		RTS and CTS of X9 are not connected
JP38	1-2			DTR signal (pin 6 of X9) is used as reset source
(DTR/RTS)	2-3			RTS signal (pin 7 of X9) is used as reset source
JP43		Closed		LIN transceiver for X5 is enabled
(LIN enable)		Open		LIN transceiver for X5 is disabled
JP45		Closed		LIN-UART2 is LIN Master
(LIN master)		Open		LIN-UART2 is LIN Slave
JP42		Closed		LIN bus (X9 pin 1) is powered by the board
(LIN Vbat)		Open		LIN bus (X9 pin 1) is not powered by the board

Table 3-8: UART2 Settings

3.10CAN interfaces (JP: 24, 26, 34, 35)

Two high-speed CAN-transceivers can be connected to the microcontroller’s CAN interfaces (CAN0 and CAN1).

Jumper	Setting	Description
JP24	Closed	RX0 is connected to CAN0 (X6)
(CAN0 RX)
JP26	Closed	TX0 is connected to CAN0 (X6)
(CAN0 TX)
JP34	Closed	RX1 is connected to CAN1 (X8)
(CAN1 RX)
JP35	Closed	TX1 is connected to CAN1 (X8)
(CAN1 TX)
	Table 3-9: CAN Settings

© Fujitsu Microelectronics Europe GmbH - 21 - FMEMCU-UG-960014-10