8 I2C Bus, Emulator System, Emulation System

SK-96370-144PMC-GDC User Guide

Chapter 1 Overview

1.3.8 I2C Bus

Additional 10 kOhm pull-up resistors can be connected to the I²C bus lines by setting the according jumpers. JP9 is for SDA0 and JP10 for SCL0.

1.3.9 Emulator System

If the board is used as an emulator target board, the microcontroller must be removed from the socket and the corresponding probe cable has to be mounted:

Series

MB96370

V-Chip

MB96V300B

Probe cable

MB2198-507-E

Socket

NQPACK144SD-ND

HQPACK144SD

Table 1-1: Emulation System

- 9 -

FMEMCU-UG-960014-10

Page 9

Image 9

Fujitsu MB96300 manual 8 I2C Bus, Emulator System, Emulation System

Contents

MB96300 Series Revision History Date Issue No Liability for Consequential Damages Warranty and Disclaimer Contents Programming the Internal Flash Memory Abstract Overview Features General Description 8 I2C Bus Emulator SystemEmulation System Installation Connection/Power-OnDo not use any other probe cable than MB2198-507-E only Jumper Description / Function Type Default Coordinates Default Jumper settings for MB96370 Series Flash / Lime Jumper Settings Jumper Location Default Jumper Settings Jumpers and Switches Operating Mode S1MCU Operating Mode Power Supply Configuration Power Supply S2, JP 8, 15, 16, 17JP8 Mcuvcc JP1 Subclock JP 1JP2 JP2 Alarm Comparator JP Analog Power Supply Voltage JP 11, 12, 13Alarm Comparator ADC Supply Uart Reset Reset Generation JP 33, 41, 46, 47Reset Connection RST MCU User Buttons SW1, SW2, SW3, SW4, SW5, SW6 JP 3, 4, 5, 6 I2C pull-up resistor JP 9User Push Buttons UART0 Settings LIN / UartLIN-UART 0 JP 19, 21, 23, 25, 27, 28, 29 Can Settings UART2 SettingsLIN-UART 2 JP 36, 37, 38, 39, 40, 42, 43 Can interfaces JP 24, 26, 34 11 Flash Configuration Jumpers 10 External Flash ConfigurationExternal Flash memory JP 49, 52 External Sram memory JP 50, 53 Glrst Flrst12 Graphic Display Controller interface Power connector ConnectorsMCU pin header connectors X20A, X20B, X21, X22 LIN-UART connectors X5 Can Connector Signals Can Connector X6Canl Canh User LEDs/LCD USER-LEDs & optional LC-Display J1 MD0 In-Circuit-Programming ConnectorRstx SIN3 VCC Connector J7 Alarm Comparator Connector J2GND Connector J8 External Supply Voltage Vin J3 Jumper Settings for Programming via Uart 0 Asynchronous ModeJumper Settings for Programming via Uart 2 Programming the internal Flash memory Reset optional Jumper Settings for reset signalFlash Programming Flash Programming Socket Synchronous Mode Related Products Appendix Http//mcu.emea.fujitsu.com Information in the WWW Evaluation Board Emulation Board China-RoHS regulation Table of hazardous substances name and concentration Recycling Gültig für EU-LänderValid for European Union Countries