Fujitsu MCE3130AP manual 5 Bit definitions of Alternate Status register, ATA Command register

4.3.1.1Alternate Status register

This register contains the same information as that of the ATAPI Status register, except that the ODD does not recognize interrupts when reading this register. Therefore, the ODD does not clear the INTRQ signal and does not clear interrupts during the pending.

Table 4.5 Bit definitions of Alternate Status register

7	6	5	4	3	2	1	0
BSY	DRDY	Reserved	SERVICE	DRQ	CORR	Reserved	CHECK	Read
		(0b)			(0b)	(0b)

4.3.1.2ATA Command register

This register contains a command to be passed to the ODD. The ODD starts executing a command immediately after the command is written in this register. For executable commands and required parameters, see Table 4.39.

4.3.1.3Data register

The data register is used for data transfer. The data width is always 16 bits.

4.3.1.4Device Control register

This register's bits are defined as shown below.

		Table 4.6 Bit definitions of Device Control register
7	6	5	4	3	2	1	0
Reserved	Reserved	Reserved	Reserved	Reserved	SRST	nIEN	0	Write

!Bits 7 to 3 are reserved. The ODD ignores all value sets in these bits.

!SRST is a reset bit for host software.

!nIEN is an enable bit for device interrupts to the host. When nIEN is 0 and the device is selected, the INTRQ signal is enabled by the tri-state buffer. When nIEN is 1 or the device is not selected, the INTRQ signal is in the high-impedance state.

4 - 6 C156-E142-02EN