130
Chapter 5 Operations after OS Installation
5Set as follows.
1. In the [Write debugging information] section, select the memory dump file type.
• Small memory dump (64KB)
Minimum information is recorded to the memory dump file.
Each time a fatal error occurs, a new file is created in the directory specified in [Small
dump directory].
• Kernel memory dump
Only kernel memory is recorded to the memory dump file.
• Complete memory dump (Recommended)
The whole system memory information is recorded to the memory dump file.
2. In [Dump file] or [Small dump directory], specify the directory to save the memory
dump file, with its full path.
In case of kernel memory dump or complete memory dump, if [Overwrite any existing file]
is checked, debugging information is overwritten to the specified file every time.
6Click [OK] to close the [Startup and Recovery] window.
7Click [OK] to close the [System Properties] window.
8Restart the system.
The setting is enabled after the system is restarted.
■Paging File Setting
Set up the paging file according to the following procedures.
1Log on to the server with administrator privileges.
2Check free space of the drive where the system is installed.
Check the required amount of free space according to "■ Checking Hard Disk Free Space"
(pg.128).
If the drive has no free space, refer to "■ Cannot Collect the Memory Dump" (pg.263).
3Click [Start] → [Control Panel] → [System].
The [System Properties] window appears.
4Click the [Advanced] tab and click [Settings] in [Performance].
The [Performance Options] window appears.