254
Chapter 9 Operation and Maintenance
■Floppy Disk Drive
●Cannot read or write to the floppy disk.
The head may be dirty. Clean the drive using a cleaning disk.
For cleaning methods, refer to "9.1.2 Cleaning" (pg.248).
●Cannot write to the floppy disk.
The write protection of the floppy disk may be applied. Flip the switch on the disk to allow writing.
■CD-ROM Drive Unit
●Cannot read data.
• Check to see whether the CD-ROM is inserted properly.
If it is not inserted, correctly insert the CD-ROM so that the label is facing up.
• Check to see whether the CD-ROM is not dirty.
If it is dirty, wipe it with a soft, dry cloth.
• Check to see whether the CD-ROM is not scratched or bent.
If scratched or damaged, replace the CD-ROM.
●The unit does not operate properly.
• The CD-ROM drive unit may not be recognized at the next startup after installation of fiber channel
card in a Windows Server 2003 server. Perform the steps in "● Fibre Channel Controller" (pg.182)
in "7.5.2 Installable Expansion Cards and Notes", then it will be recognized.
• Check to see whether the internal cable is connected properly.
If it is not connected, correctly connect the internal cable. For the connection location, refer to "7.10
Connection of Optional Devices" (pg.201).
■SCSI Device (Internal/External)
●The unit does not operate properly.
• Check to see whether the internal cable is connected properly.
If it is not connected, correctly connect the internal cable.
• Check to see whether the jumper pins are set properly.
If they are not set, correctly set the jumper pins. For settings, refer to "8.1 Jumper Pin Settings"
(pg.206).
• Check to see whether the SCSI IDs and terminator are set properly.
If they are not set, correctly set the SCSI ID and terminator.