Furuno 851 MARK-2 installation manual Installation Check List, TDH TDC Shield

2. WIRING

Shield

Other Equipment

(Echosounder data not output.)

Solder

TD-H 1

TD-C 2

RD-H 3 RD-C 4

5 SHIELD 6

MODEL 851	10mm 10mm 10mm 10mm
MARK-2
OPTION connector

FM-C6FPS001

Figure 2-8

RD_H

RD_C

SHIELD

Echosounder

TD_H

TD_C

SHIELD

4. Cover shield with steel mesh by cable ties.

Shield

	Steel mesh	Cable tie
MODEL851 MARK2		Other Equipment
OPTION connector		Echosounder
		After tieing, wrap with
		self-vulcanizing tape.

Figure 2-9

5.Wrap with self-vulcanizing tape.

2.5Installation Check List

After completing the installation it is a good idea to check for proper installation. Follow the checklist below and tick boxes to show proper completion.

!Is the signal cable secured against a mast or bulkhead?

!Is the cable gland or cable entry on the deck fully waterproofed?

!Are the connections to the battery correct polarity?

!Are all the antenna and display units grounded?

!Are all connectors at the rear of the display unit fastened securely?

2-6