2.Use ▲ or ▼ to set the cursor where desired. Picture advancement is stopped until step 3 is completed.
3.Press the [MARK] key again. The latitude and longitude position at the cursor is output to the navigator and a vertical line marks location. Further, the display shows the waypoint name (next sequential number) and position of the location selected at step 2.
|
| WAYPOINT | |
|
| FREQ. | |
| Name | ||
|
|
| 05 |
| Lat |
| : 34° 22.796'N |
| Lon |
| : 136° 07.264'E |
Erase?
[MENU]: Exit
Waypoint data display
Registering waypoint from the waypoint list
1.Press the [MENU/ESC] key to open the menu.
2.Use ▲ or ▼ to choose WAYPOINT LIST from page 2 of the menu.
3.Press ►.
WAYPOINT LIST
0101
0203
03
[MENU]: Exit
Note: If you attempt to enter 13th waypoint, the message “Memory full!” appears. In this case, erase an unwanted waypoint to enable entry.
4.Press the [MENU/ESC] key to save the waypoint under the name shown, or go to step 5 to change its name.
5.Press ► to open the waypoint name entry window.
| WAYPOINT |
Name FREQ. | |
Lat | |
: 34° 22.796'N | |
Lon | : 136° 07.264'E |
Erase? | |
[MENU]: Exit | |
Waypoint window, name entry
6.Use ▲ or ▼ to set character; ◄ or ► to shift cursor. The name may consist of eight alphanumeric characters.
Note: Character order is
0→1…9→A→B…Z→0…
7.Press ► to choose ENT.
8.Press the [MENU/ESC] key to register the waypoint.
Waypoint list
4.Choose an empty waypoint and press ►. Press ► again.
NEW WAYPOINT | |
Name FREQ. | |
Lat | |
: 34° 22.796'N | |
Lon | : 136° 07.264'E |
Erase? | |
[MENU]: Exit | |
New waypoint window, name entry
5.Use ▲ or ▼ to set character; ◄ or ► to shift cursor.
6.Press ► to select ENT.
7.Enter latitude and longitude, similar to how you entered waypoint name
8.Press the [MENU/ESC] key to register the waypoint.
Setting destination waypoint
Set a destination waypoint to find range, bearing and
1.Press the [MENU/ESC] key to open the menu.
11
