press any key after the completion of the equipment check to start operation sooner.
LS6"
FURUNO ELECTRIC CO., LTD.
Note 1 : Setting windows other than those on menus are erased if there is no operation within about seven seconds.
Note 2: When the power is reapplied after turning off the equipment with minimum brilliance, minimum brilliance will be set after the equipment goes through its initial start up. Adjust the brilliance as necessary.
ROM : OK RAM : OK
Program No:
** Program version no.
Start-up screen
To turn off the power, press and hold down the [POWER/BRILL] key until the screen goes blank. The time remaining until power is turned off is counted down on the screen.
Note: The example screens shown in this manual may not match the screens you see on your display. The screen you see depends on your system configuration and equipment settings.
1.3Adjusting Display Contrast, Brilliance
1.Press the [POWER/BRILL] key momentarily to show the brilliance/contrast adjustment window.
|
| Min |
|
| Max | |
CONTST |
|
| 4 |
|
| |
|
|
|
|
|
|
|
|
| Min |
|
| Max | |
|
|
|
|
|
|
|
BRILL |
|
|
|
|
|
|
|
| 9 |
|
| ||
|
|
|
|
|
|
|
Brilliance/contrast adjustment window
2.For contrast, press the [POWER/BRILL] key to adjust contrast cyclically. (You may also use ◄ or ► on the Cursor Pad to adjust contrast.)
3.To adjust brilliance, use ▲ or ▼.
4.Press the [MENU/ESC] key to close the brilliance/contrast adjustment window.
1.4Choosing a Display, Frequency
Seven displays are available: single frequency (50 or 200 kHz), dual frequency,
1.Press the [MODE] key to show the mode selection window.
MODE
SINGLE FREQ.
DUAL FREQ.
MARKER ZOOM
BOTTOM ZOOM
BOTTOM LOCK
NAV
NAV
50kHz 200kHz
Mode selection window
2.Press the [MODE] key again within seven seconds to choose a mode. You may also choose a mode with ▲ or ▼.
3.For modes other than DUAL FREQ, choose frequency; press ◄ for 50 kHz; ► for 200 kHz.
4.Press the [MENU/ESC] key to close the menu.
2
