Furuno LS-6100 manual Optional equipment, Pin arrangement on Nmea port, Water temp/speed sensor

not use an “open” type lug ().

Optional equipment

Pin arrangement on NMEA port

Connector		Remarks
1	TD-A	IEC-61162-1/NMEA0183
2	TD-B
3	RD-A	IEC-61162-1/NMEA0183
4	RD-B
5	+Vout	Power output max. 100 mA*
6	GND
7	FG

*= The LS-6100 can feed 12 V power to GP-310B, GP-320B. The power voltage must be at least 12 V to feed power to those units.

5.Use ▲ or ▼ to choose Off or On. Choose On to output input data.

6.To restore normal operation, turn off the power and then turn it on again.

Water temp/speed sensor

Connect the optional water temp/speed sensor to the XDR connector with the optional converter connector (Type 02S4147) as shown below.

Connect to XDR port at rear of display unit

MJ-A10SPF

NMEA port setup

The NMEA port can function as an input port or input/output port. Change the setting to “In/In” when connecting GP-310B and a wind sensor.

When connecting the GP-320B and a wind sensor, first turn on “GPS WAAS” (in the Installation menu) and then select “In/In” as

MJ-A6SRMD

Tape connectors with

vulcaninzing tape and then vinyl tape to waterproof them. Bind tape ends with cable ties to prevent

From tape from unraveling. sensor

MJ-A10SRMD

From transducer

the NMEA port setting.

1.Turn on the power while pressing and holding down the [MENU/ESC] key. Continue pressing the [MENU/ESC] key until the Installation menu appears.

2.Choose NMEA PORT, and then press ► to display the NMEA port options window.

3.Use ▲ or ▼ to choose In/Out or In/In as appropriate.

In/Out: Input and Output (default setting)

In/In:Input only (Available with connection of the GP-310B and a wind sensor.)

4.Press ◄, choose NMEA MIX, and then press ► to display the NMEA MIX options window.

Connection of converter

connector 02S4147 GP-320B Æ￿

DISPLAY UNIT ¨

GPS Receiver GP-320B

GPS Navigator GP-32,etc.

12 VDC

NMEA port setting: IN/OUT

Connection of GP-320B

35