9. Remedying slight malfunctions yourself
Not every malfunction can be ascribed to a defect of your cooker. If your appliance should not function properly, search for the fault in the list below.
If you are not successful in remedying the fault with the aid of the list below, then contact your Gaggenau
Fault | Possible cause | Remedy |
The appliance cannot be | No electricity. | Check the domestic fuse. |
switched on. | Objects lie on the control panel. | Remove objects. |
The appliance cannot be | The child lock is switched on. | Switch off the child lock. |
switched on, the main |
|
|
switch symbol blinks. |
|
|
Both right cooking zones | The overheating protection has | It is possible to use the |
are switched back to level 7. | been triggered. | remaining cooking zones. |
H blinks on the cooking level |
| After cooling down the |
display. |
| complete cooktop can be |
|
| used once again. |
|
|
|
A cooking zone switches off | The holiday safeguard is set to | Switch the cooking zone on |
after operating for a longer | automatically switch off a cooking zone | again as usual. |
period of time. | 4 hours after the last operation. |
|
|
|
|
No reaction from the cooktop. Extremely excessive voltage in the mains, e.g. caused by lightning.
Control panel is soiled.
The main switch was not touched long enough.
Isolate the appliance from the for 30 sec by switching off the domestic fuse.
Clean control panel. Always keep the control panel clean. Touch the main switch again.
The display panel lights, a | The appliance is on | Disconnect the appliance |
spot lights constantly on | show room mode. | from the power supply. |
the timer display panel, |
| Reconnect the appliance and |
however the cooking zone |
| within 3 minutes carry out the |
does not heat up. |
| following procedure: Touch |
|
| the + symbol and keep the |
|
| finger pressed down. Touch |
|
| the main switch until you |
|
| hear a signal. Immediately |
|
| remove your finger from the |
|
| main switch and then release |
|
| the + symbol. |
|
|
|
26