Page 18 Part # MCOSM06 Rev 1 (11/03/08)
1. Press and hold PROG key for three (3) seconds - all the
product key LEDs light.
2. CODE will be displayed. The controller is asking for the
access code. Press 4-2-7-5 and the START/CANCEL key.
PROD will be displayed indicating you have gained access
to Product Programming.
3. Press the product key (1 - 9) into which you want to store
a cooking program. SHLF will be displayed. The control is
asking if you want to program the key as a shelf timer or
with a cooking prole. Select your answer by pressing the
START/CANCEL key. When the correct answer is displayed,
press the SET key. The TIME LED will light. 30:00 will be
displayed.
4. Set rst cook time using dial. If more than one cooking
prole is desired:
 •presstheproductkeywheretheprogramistobestored
(1 - 9) - PR-2 will be displayed.
 •setthesecondcooktimeusingthedial(factorypresets
for PR-2 through PR-5 are :00).
 •pressthesameproductkey(1-9)again-PR-3willbe
displayed.
 •Repeatthisprocessforallproles.Whenthelastprole
time has been entered, press the SET key, OR
If less than ve (5) proles are desired press the SET key
after the last required prole - PRE will be displayed,
followed by :00. The controller is asking if you would like a
reminder alarm (pre-alarm) to sound during the cooking
process. (factory preset is :00).
5. If a pre-alarm signal is desired - dial in the time that the
alarm is to sound. (Ex. If the product is to be turned
halfway through the 60 minute cooking cycle, set the
pre-alarm to 30 minutes). If pre-alarm is not desired verify
that ":00" is displayed. Press the SET key - TEMP Led will
light, and the display will show the rst prole cooking
temperature. (factory preset at 350°F).
6. Set the rst cooking temperature using the dial.
Press the product key - PR-2 will be displayed followed by
the second temperature.
Set the second cooking time using the dial.
Repeat as you did for cooking time, for all the proles
desired.
NOTE: The controller will only accept cooking temperatures
for the number of proles for which a cooking time
has been set. If the product key is pressed after the
last programmed prole, the rst temperature will be
displayed.