INSTALLATION/OPERATION MANUAL | GARLAND ELECTRIC CLAMSHELL GRILL WITH PRODUCT RECOGNITION MODEL MWE3W |
INSTALLATION (continued)
1. Uncrate unit from crating material
IMPORTANT: RATING PLATE FOR THIS EQUIPMENT IS LOCATED IN TWO PLACES. ONE IS LOCATED INSIDE BACK PANEL ON LEFT SIDE, SECOND RATING PLATE LOCATED UNDER FRONT CONTROL PANEL IN CENTER.
CAUTION: Prior to installation, check the electrical supply to ensure input voltage and phase match the equipment voltage rating and phase. See data plate located rear left side of grill. Back panel removal is required.
NOTE: ENSURE THAT PLATENS ARE STRAPPED DOWN TO PREVENT PLATENS FROM RAISING. SEVERE DAMAGE MAY OCCUR.
3.Carefully rotate grill back on its casters.
4.Remove back body side and Install power cords per your country / areas specifications.
MWE3 Standard Electrical Cord Hookup
2 x 50AMP NEMA
1 x 20AMP NEMA
E
Lim Lim 120 120 Com Wht Wht Wht Ora Red Blk
E
Lim
Lim 120 120 Com Wht Wht Wht Ora Red Blk
WARNING: Electrical appliances must be electrically grounded in accordance with local codes or in the absence of local codes, with national electric code ANSI/NFPA
- latest version.
5. Install grease bucket rails as shown below:
2. Tip unit over on its back, and install casters. Lock jam nuts in place.
Page 10 | PART #4521777 (03/19/08) |
