INSTALLATION/OPERATION MANUAL | GARLAND ELECTRIC CLAMSHELL GRILL WITH PRODUCT RECOGNITION MODEL MWE3W |
INSTALLATION OF RELEASE MATERIAL
The following are the procedures for installing the teflon sheets on the upper platen on the Garland Clamshell grill. The components shown below are included with your grill when purchased.
1.Slide release material rod through hemmed end of the release material sheet.
HEMMED
LOOP
MATERIAL
ROD
RELEASE
MATERIAL
“Teflon Sheet” available from your DC Saint Gobain: DC WRIN #
2.Hook release material rod on brackets located at the rear of the upper platen.
4.Place locking clips over release material sheet and press into place over release material bar.
LOCKING
CLIP
RELEASE
MATERIAL
MATERIAL
ROD
UPPER
PLATEN (SIDE VIEW)
5.Check alignment and tightness of release material against upper platen.
NOTE: Installing release material sheets too tight may cause premature failure of the sheet. Installing only 1 clip on over the release material bar may cause the release material sheet to be too loose. Ensure that 2 clips are installed on the teflon bar at all times.
UPPER
PLATEN (SIDE VIEW)
RELEASE
MATERIAL
MATERIAL ROD
HOLDER
MATERIAL ROD
Release material sheets should be replaced when:
Product sticks to release material
Carbon
A tear in the release material sheet’s cooking area.
3.Holding the bottom of the release material sheet in place, gently pull the sheet toward the front of the platen.
NOTE: Make sure release material fits smoothly over upper platen.
Release material coating is worn off sheet.
NOTE: Rotate the release sheets on daily basis
Page 12 | PART #4521777 (03/19/08) |