GarrettCom 6K32 manual Four-Port 10 Mb mm Fiber ST Modules

Magnum 6K32 Managed Switch Installation and User Guide (02/05)

mode fiber ST, SC or single mode SC or Long Reach SC ports. For ports numbering, ports 1,3,5,7 are copper, ports 2 and 6 are fiber, ports 4 and 8 are not present.

The four RJ-45 ports operate just like the 8-port copper module, and the two fiber ports operate at 100Mbps full-duplex (default). User mode control per port through the MNS software is also the same. See Section 4.3 for Up-Link switch on port 1.

On Magnum “4+2” Combo modules, there are four LED’s for each RJ-45 port, which indicate status the same as described for the 6K8-RJ45 in Section 2.2.3 above. The fiber port’s LEDs indicate status the same way as described for the SFF fiber modules in Section 2.2.2 above. Color-coding on the panel of the module shows which LEDs belong to which port.

The Magnum Combo

1

3

5

7

six-port modules are also available

10/100

LK

ACT

with 4@ MTRJ 100Mb mm SFF

F/H

fiber and 2@10Mb fiber mm ST

ACT

ACT

F/H

F/H

ports, and with 4@ RJ45 10/100

2

TX

LK RX

6

TX

LK

RX

copper and 2@10Mb fiber mm ST

ports. The 4@ RJ-45 + 2@ 10 Mb ST

operation of the SFF fiber

and the RJ-45 half

of the module is as described for those port types above. For detailed

information about 10Mb mm ST fiber half of the module, please check section 2.2.5.

2.2.5Four-Port 10 Mb mm Fiber ST Modules

ACT			ACT
F/H			F/H
1	TX	LK RX	5	TX	LK RX
ACT			ACT
F/H			F/H	T	LK	R
2	TX	LK RX	6

The 4port @10Mb ST fiber modules behave the same as the 8@100Mb ST fiber modules except for the 10Mb speed. For ports numbering, ports 1, 2, 5, 6 are present, ports 3, 4. 7, 8 are not present. The default setup on the 10Mb fiber module is half-duplex, which allows the Magnum 6K32 Switch to connect to any 10Mb hub or media converter or almost any other device with a 10Mb fiber Ethernet port. User mode control per port through the MNS software is the same as the other 6K32 modules. The fiber ports support fiber cabling distances according to the 10BASE-FL standard, i.e., 2km distance for multi-mode fiber. (Single-mode for up to 10Km distance may be available as a special order configuration).

www . GarrettCom . com

11