GarrettCom manual Magnum 6K32 Managed Switch Port Modules, Inspecting the Package and Product

	Magnum 6K32 Managed Switch					Installation and User Guide (02/05)
	GBIC-	1000Mb	Single-	25	1550	9/125	-4.0	-21	15	37.5	17.5	43
			mode
LXSC25
	GBIC-	1000Mb	Single-	40	1550	9/125	-4.0	-21	15	60	17.5	70
			mode
ZXSC40
	GBIC-	1000Mb	Single-	70	1550	9/125	-3.0	-23	18	90	20.5	102
			mode
ZXSC70

*Note: The use of either multi-mode or single-mode fiber to operate at 100Mbps speed over long distances (i.e., in excess of approx. 400 meters) can be achieved only if the following factors are both applied:

•The 100Mb fiber segment must operate in full-duplex (FDX) mode, i.e. the full-duplex (factory default) setting for 100Mbps fiber ports must be used, and

•The worst-case OPB of the fiber link must be greater than the fiber cable’s passive Attenuation.

(Attenuation = Cable loss + LED aging loss + Insertion loss + safety factor)

5.0Magnum 6K32 Managed Switch Port Modules

This chapter describes each Port Module (PM), including appearance, functionality, and status displays.

5.1Inspecting the Package and Product

This section applies only to PMs shipped as separate items, i.e., 6K32 PMs not factory installed in a Magnum 6K32 modular slot.

Examine the shipping container for obvious damage prior to installing a 6K32 PM; notify the carrier of any damage you believe occurred during shipment or delivery. Inspect the contents of this package for any signs of damage and ensure that the items listed below are included.

This package should contain:

6K32 PMs

Installation instructions, with illustrations

Remove the 6K32 PM(s) from the shipping container. Be sure to keep the shipping container should you need to ship any of the PMs separately at a later date. In the event there are items missing or damaged, contact your supplier. If you need to return the unit, use the original shipping container if possible. Refer to Chapter 5 for specific return procedures.

www . GarrettCom . com

39