Magnum 6K32 Managed Switch | Installation and User Guide (02/05) |
NOTE:. When leaving 6KPM slots empty, always use a face plate (Magnum 6K8- BLNK) to cover the slot opening in the front panel. This will maintain proper cooling air flow, safety, and operation as required by FCC, CE, and other regulations.
Step 6. Now screw down the daughter board with 7 #440 screws except the last two at the end, so that it holds the daughter board securely. The figure below shows the top view of 6KPM card after successfully installing the 6KPM cards inside the
Magnum 6K32.
Fig. 3.5.2g Top View : 6KPM Module installed inside a 6K32 Switch
Step 7. Once the installation of granddaughter and daughter modules is done properly, the front panel screen plates(come along with the
Step 8. Once the 6KPM cards have been installed, the chassis top cover should be replaced by matching at the two front corners properly and slide in until it reaches the rear end and fit properly to match the holes. Make sure the chassis cover is aligned properly before securing the enclosure. Place the front panel part at the end by sliding in to the front side and secure it with 12 screws as being mentioned earlier.
NOTE (Reverse mount Model): The Reverse model require a LED Decal, (for checking the speed, F/H, and activity status)
3.5.3Removing 6KPM Cards
To properly remove a 6KPM card from the 6K32 Managed Switch, follow the 3 steps below.
Step 1. Remove chassis cover See procedures in Section 3.5.1 above.
Caution: Be sure the power cord is unplugged.
www . GarrettCom . com
31
