GarrettCom 6K32 manual Before Calling for Assistance, When Calling for Assistance

Models: 6K32

1 65
Download 65 pages 6.87 Kb
Page 57
Image 57

Magnum 6K32 Managed Switch

Installation and User Guide (02/05)

suggestions listed below prior to contacting your supplier. However, if you are unsure of the procedures described in this section or if the Magnum 6K32 Switch is not performing as expected, do not attempt to repair the unit; instead contact your supplier for assistance or contact GarrettCom Customer Support.

6.1Before Calling for Assistance

1.If difficulty is encountered when installing or operating the unit, refer back to the Installation Section of the applicable chapter of this manual. Also check to make sure that the various components of the network are interoperable.

2.Check the cables and connectors to ensure that they have been properly connected and the cables/wires have not been crimped or in some way impaired during installation. (About 90% of network downtime can be attributed to wiring and connector problems.)

3.Make sure that an AC power cord is properly attached to each Magnum 6K32 Switch unit. Be certain that each AC power cord is plugged into a functioning electrical outlet. Use the PWR LEDs to verify each unit is receiving power.

4.If the problem is isolated to a network device other than the Magnum 6K32 Switch product, it is recommended that the problem device be replaced with a known good device. Verify whether or not the problem is corrected. If not, go to Step 5 below. If the problem is corrected, the Magnum 6K32 Switch and its associated cables are functioning properly.

5.Always check your Switch configuration, specially Auto-negotiation behavior with other connected device to have proper setup tested.

5.If the problem continues after completing Step 4 above, contact your supplier of the Magnum 6K32 Switch unit or if unknown, contact GarrettCom, Inc.by fax, phone or email (support@garrettcom.com) for assistance.

6.2When Calling for Assistance

Please be prepared to provide the following information.

1.A complete description of the problem, including the following points:

a.The nature and duration of the problem;

b.Situations when the problem occurs;

c.The components involved in the problem; (complete Network diagram

www . GarrettCom . com

51

Page 57
Image 57
GarrettCom 6K32 manual Before Calling for Assistance, When Calling for Assistance