GarrettCom user manual Installing 6KPM Cards in the Magnum 6K32T

Magnum 6K32 & 6K32T Managed Switch	Installation and User Guide (12/05)
	Looking down into the
	Magnum 6K32T unit, notice that
	there are individual PM
	installation spaces and female
	latch (white) connectors
	provided on the far right side of
	main board along with four
	stand-off’s for 6KPM card
	position. (See Figure 3.5.1c).

Figure 3.5.1c: Magnum 6K32T modular slot side (front-right side), without chassis cover

Step 3. Remove front panel face plate retaining screws

There are one PM slot located on the front-right side of the chassis cover. Looking into the vertical placed Chassis cover of the unit, there are one bracket with retaining screws (#256 flat head ) which hold the PM Face plate card slot securely. These six screws shown in the picture below are used to secure a PM face plate in position, but unscrew only four of the screws as shown in Fig. below. These screws are also used to secure the individual 6KPM cards screen plate which can be subjected to significant forces from the attached cables. (See Figure 3.5.1d)

Figure 3.5.1d: Top View – 6KPM retaining screws hold Face Plate

3.5.2Installing 6KPM Cards in the Magnum 6K32T

Up to four front-mounted 6KPM cards may be installed in one Magnum 6K32T Managed Switch unit. Follow these steps to install a 6KPM.

Step 1. Remove top chassis cover. See procedure in Section 3.5.1 above.

www . GarrettCom . com

32