8Replace the expansion slot cover bracket and tighten the thumbscrew.
9Replace the card guide by sliding it back to its original position until it clicks in place. Make sure the end of the card is in the right slot in the card guide.
10Connect any cables to the card (see card documentation for proper cable orientation).
11Close the case. (See “Closing the case” on page 20.)
12Reconnect the peripherals and the power cord, then turn on the system.
You may need to reconfigure the server after replacing an expansion card. You may also need to install upgrade software that came with the card. Check the card documentation for additional information.
Adding an expansion card
When adding an expansion card, you must install an expansion card in slot 1 before you can install an expansion card in slot 2.
To add an expansion card:
1Set any jumpers and switches on the card, if required in the card instructions.
2Turn off the server, disconnect the power cord and all external peripheral devices.
3Open the case. (See “Opening the case” on page 18 and “Preventing static electricity discharge” on page 17.)
48Replacing and Adding Internal Devices